NETGEAR ProSafe GSM7224P - Ip Dhcp Snooping Trust; Ip Dhcp Snooping Log-Invalid

Switching Commands
148
ProSafe Managed Switch
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the
burst level, to the defaults.
Format no ip dhcp snooping limit
Mode
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping
application.
Default
Format ip dhcp snooping log-invalid
Mode
no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping
application.
Format no ip dhcp snooping log-invalid
Mode
ip dhcp snooping trust
Use this command to configure the port as trusted.
Default
Format ip dhcp snooping trust
Mode
no ip dhcp snooping trust
Use this command to configure the port as untrusted.
Format no ip dhcp snooping trust
Mode
Format ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode
Interface Config
Interface Config
disabled
Interface Config
Interface Config
disabled
Interface Config
Interface Config