NETGEAR ProSafe GSM7224P - Lldp Transmit-Tlv

Switching Commands
187
ProSafe Managed Switch
range is 2-10. The <reinit-seconds> is the delay before re-initialization, and the range is
1-0 seconds.
Default
• interval—30 seconds
• hold—4
• reinit—2 seconds
Format lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit
<reinit-seconds>
]
Mode
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format no lldp timers [interval] [hold] [reinit]
Mode
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use sys-name to transmit the system
name TLV. To configure the system name, see snmp-server on page 628. Use sys-descto
transmit the system description TLV. Use sys-cap to transmit the system capabilities TLV.
Use port-desc to transmit the port description TLV. To configure the port description, see
description on page 40
Default
Format lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Format no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
Global Config
Global Config
all optional TLVs are included
Interface Config
Interface Config