NETGEAR ProSafe GSM7224P - Ip Pim Sparse(Global Config); Ip Pim Bsr-Border; Ip Pim Bsr-Candidate

IP Multicast Commands
332
ProSafe Managed Switch
ip pim sparse(Global Config)
This command is used to administratively enable PIM Sparse Mode (PIM-SM) multicast
routing mode on the router.
Default
Format ip pim sparse
Mode
no ip pim sparse(Global Config)
This command is used to administratively disable PIM-SM multicast routing mode on the
router.
Format no ip pim sparse
Mode
ip pim bsr-border
Use this command to prevent bootstrap router (BSR) messages from being sent or received
through an interface.
Default
Format ip pim bsr-border
Mode
no ip pim bsr-border
Use this command to disable the interface from being the BSR border.
Format no ip pim bsr-border
Mode
ip pim bsr-candidate
This command is used to configure the router to announce its candidacy as a bootstrap
router (BSR).
Default
Format ip pim bsr-candidate {interface <interface-num> [hash-mask length]
[bsr-priority]}
Mode
disabled
Global Config
Global Config
disabled
Interface Config
Interface Config
None
Global Config