NETGEAR ProSafe GSM7224P - Aaa Authentication Enable

Management Commands
625
ProSafe Managed Switch
no aaa authentication login
Use this command to remove authentication at login.
Format no aaa authentication login {default | list-name}
Mode
aaa authentication enable
Use this command to set authentication when the user access higher privilege level, use the
aaa authentication enable default command in global configuration mode. The default
and optional list names that you create with the
aaa authentication enable command are
used with the
enable authentication command.
Create a list by entering the
aaa authentication enable list-name method command
where
list-name is any character string used to name this list. The method argument
identifies the list of methods that the authentication algorithm tries, in the given sequence.
The additional methods of authentication are used only if the previous method returns an
error, not if it fails. To ensure that the authentication succeeds even if all methods return an
error, specify
none as the final method in the command line. For example, if none is specified
as an authentication method after
radius, no authentication is used if the radius server is
down. All
aaa authentication enable default requests sent by the switch to a RADIUS
or TACACS server include the username "
$enabx$.", where x is the requested privilege level.
.
Default Uses the listed authentication methods that follow this argument as the default list of
methods when a user accesses a higher privilege level.
list-name Character string used to name the list of authentication methods activated when a
user accesses a higher privilege level. Up to 12 characters.
method1 [method2…] At least one from the following table:
enable
line
none
radius
tacacs
Global Config
Format aaa authentication enable {default | list-name} method1 [method2...]
Mode
Global Config
Keyword Description
Uses the enable password for authentication.
Uses the line password for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication. Uses username
"$enabx$."where x is the privilege level.
Uses the list of all TACACS servers for authentication. Uses username
"$enabx$." where x is the privilege level.