NETGEAR ProSafe GSM7224P - Virtual Router Redundancy Protocol Commands

Routing Commands
254
ProSafe Managed Switch
show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Format show ip vlan
Modes
• Privileged EXEC
• User EXEC
MAC Address
used by
Routing VLANs
VLAN ID
Logical
Interface
IP Address
Subnet Mask
Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default
Format ip vrrp
Mode
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of
VRRP on the router.
Format no ip vrrp
Mode
Term Definition
The MAC Address associated with the internal bridge-router interface (IBRI). The same
MAC Address is used by all VLAN routing interfaces. It will be displayed above the
per-VLAN information.
The identifier of the VLAN.
The logical unit/slot/port associated with the VLAN routing interface.
The IP address associated with this VLAN.
The subnet mask that is associated with this VLAN.
none
Global Config
Global Config