Management Commands
598
ProSafe Managed Switch
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format no transport input telnet
Mode
transport output telnet
Use this command to regulate new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active until
the session is ended or an abnormal network error ends it.
Default
Format transport output telnet
Mode
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format no transport output telnet
Mode
session-limit
Use this command to specify the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
Default
Format session-limit <0-5>
Mode
Default
enabled
Format transport input telnet
Mode
Line Config
Line Config
enabled
Line Config
Line Config
5
Line Config
To Next Page
Loading...
