NETGEAR ProSafe GSM7224P - DHCP and BOOTP Relay Commands

Routing Commands
263
ProSafe Managed Switch
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies
between clients and servers when they are not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
Format bootpdhcprelay cidoptmode
Mode
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format no bootpdhcprelay cidoptmode
Mode
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay
on the system. The <hops> parameter has a range of 1 to 16.
Default
Format bootpdhcprelay maxhopcount <1-16>
Mode
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP
Relay on the system.
Format no bootpdhcprelay maxhopcount
Mode
Mode
Indicates whether the virtual router is enabled or disabled.
State
The state (Master/backup) of the virtual router.
disabled
Global Config
Global Config
4
Global Config
Global Config
Term Definition