NETGEAR ProSafe GSM7224P - Port-Security Mac-Address; Port-Security Mac-Address Move; Show Port-Security

Switching Commands
184
ProSafe Managed Switch
no port-security max-static
This command sets maximum number of statically locked MAC addresses to the default
value.
Format no port-security max-static
Mode
port-security mac-address
This command adds a MAC address to the list of statically locked MAC addresses. The
<vid> is the VLAN ID.
Format port-security mac-address <mac-address> <vid>
Mode
no port-security mac-address
This command removes a MAC address from the list of statically locked MAC addresses.
Format no port-security mac-address <mac-address> <vid>
Mode
port-security mac-address move
This command converts dynamically locked MAC addresses to statically locked addresses.
Format port-security mac-address move
Mode
show port-security
This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to display
the settings on a specific interface or on all interfaces.
Format show port-security [{<unit/slot/port> | all}]
Mode
Admin Mode
Interface Config
Interface Config
Interface Config
Interface Config
Privileged EXEC
Term Definition
Port Locking mode for the entire system. This field displays if you do not supply any
parameters.