NETGEAR ProSafe GSM7224P - Clear Config; Clear Logging Buffered; Clear Counters; Clear Igmpsnooping

Utility Commands
529
ProSafe Managed Switch
clear config
This command resets the configuration to the factory defaults without powering off the switch.
When you issue this command, a prompt appears to confirm that the reset should proceed.
When you enter y, you automatically reset the current configuration on the switch to the
default values. It does not reset the switch.
Format clear config
Mode
clear mac-addr-table
This command clears the dynamically learned MAC addresses of the switch.
Format clear mac-addr-table
Mode
clear logging buffered
This command clears the messages maintained in the system log.
Format clear logging buffered
Mode
clear counters
This command clears the statistics for a specified <unit/slot/port>, for all the ports, or
for the entire switch based upon the argument.
Format clear counters {<unit/slot/port> | all}
Mode
clear igmpsnooping
This command clears the tables managed by the IGMP Snooping function and attempts to
delete these entries from the Multicast Forwarding Database.
Format clear igmpsnooping
Mode
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC