NETGEAR ProSafe GSM7224P - Lacp Actor Port Priority; Lacp Actor System Priority

Switching Commands
122
ProSafe Managed Switch
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format no lacp actor admin state passive
Mode
lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid
range for <priority> is 0 to 255.
Default
Format lacp actor port priority <priority>
Mode
Note: This command is only applicable to physical interfaces.
no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
Format no lacp actor port priority
Mode
lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor’s SystemID.
The range for <priority> is 0 to 65535.
Default
Format lacp actor system priority <priority>
Mode
Note: This command is only applicable to physical interfaces.
Interface Config
0x80
Interface Config
Interface Config
32768
Interface Config