NETGEAR ProSafe GSM7224P - Speed All; Show Port

100h
100f
10h
10f
Switching Commands
42
ProSafe Managed Switch
speed all
This command sets the speed and duplex setting for all interfaces.
Format speed all {<100 | 10> <half-duplex | full-duplex>}
Mode
100h
100f
10h
10f
show port
This command displays port information.
Format show port {<unit/slot/port> | all}
Mode
Acceptable
Values
Definition
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
Global Config
Acceptable
Values
Definition
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
Privileged EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Type
If not blank, this field indicates that this port is a special type of port. The possible
values are:
• Mirror - this port is a monitoring port. For more information, see Port Mirroring on
page 134.
• PC Mbr- this port is a member of a port-channel (LAG).
• Probe - this port is a probe port.
Admin Mode
The Port control administration state. The port must be enabled in order for it to be
allowed into the network. - May be enabled or disabled. The factory default is enabled.