NETGEAR ProSafe GSM7224P - Show Logging Buffered; Show Logging Hosts

Utility Commands
519
ProSafe Managed Switch
show logging buffered
This command displays buffered logging (system startup and system operation logs).
Format show logging buffered
Mode
Buffered
(In-Memory)
Logging
Buffered
Logging
Wrapping
Behavior
Buffered Log
Count
show logging hosts
This command displays all configured logging hosts. The <unit> is the switch identifier and
has a range of 1-8.
Format show logging hosts <unit>
Mode
Host Index
IP Address /
Hostname
Severity Level
Port
Host Status
Log Messages
Received
Number of messages received by the log process. This includes messages that are
dropped or ignored.
Log Messages
Dropped
Number of messages that could not be processed due to error or lack of resources.
Log Messages
Relayed
Number of messages sent to the collector/relay.
Privileged EXEC
Term Definition
Shows whether the In-Memory log is enabled or disabled.
The behavior of the In Memory log when faced with a log full situation.
The count of valid entries in the buffered log.
Privileged EXEC
Term Definition
(Used for deleting hosts.)
IP address or hostname of the logging host.
The minimum severity to log to the specified address. The possible values are
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug
(7).
The server port number, which is the port on the local host from which syslog messages
are sent.
The state of logging to configured syslog hosts. If the status is disable, no logging occurs.
Term Definition