NETGEAR ProSafe GSM7224P - IP Routing Commands

Routing Commands
237
ProSafe Managed Switch
show arp switch
This command displays the contents of the switch’s Address Resolution Protocol (ARP)
table.
Format show arp switch
Mode
IP Address
MAC Address
Interface
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.
routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current value
for this function with the show ip brief command. The value is labeled as “Routing
Mode.”
Default
Format routing
Mode
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The
value is labeled as “Routing Mode.”
Format no routing
Mode
ip routing
This command enables the IP Router Admin Mode for the master switch.
Format ip routing
Mode
Privileged EXEC
Term Definition
The IP address of a device on a subnet attached to the switch.
The hardware MAC address of that device.
The routing unit/slot/port associated with the device’s ARP entry.
disabled
Interface Config
Interface Config
Global Config