Using the Command-Line Interface
10
ProSafe Managed Switch
Command Syntax
A command is one or more words that might be followed by one or more parameters.
Parameters can be required or optional values.
Some commands, such as show network or clear vlan, do not require parameters.
Other commands, such as network parms, require that you supply a value after the
command. You must type the parameter values in a specific order, and optional parameters
follow required parameters. The following example describes the network parms
command syntax:
• network parms is the command name.
• <ipaddr> and <netmask> are parameters and represent required values that you must
enter after you type the command keywords.
• [gateway] is an optional parameter, so you are not required to enter a value in place of
the parameter.
The New Template User Manual lists each command by the command name and provides a
brief description of the command. Each command reference also contains the following
information:
• Format shows the command keywords and the required and optional parameters.
• Mode identifies the command mode you must be in to access the command.
• Default shows the default value, if any, of a configurable setting on the device.
The show commands also contain a description of the information that the command shows.
cos-queue random-detect Supported Not supported
no cos-queue random-detect Supported Not supported
random-detect exponential weighting-constant Supported Not supported
no random-detect exponential weighting-constant Supported Not supported
random-detect queue-parms Supported Not supported
no random-detect queue-parms Supported Not supported
Format network parms <ipaddr> <netmask> [gateway]
Command Group or Command XSM7224S GSM7212F/GSM7212P/
GSM7224P/GSM5212P
To Next Page
Loading...
