NETGEAR ProSafe GSM7224P - Ip Dhcp Ping Packets; Ip Dhcp Excluded-Address

Utility Commands
550
ProSafe Managed Switch
no option
This command removes the DHCP Server options. The <code> parameter specifies the
DHCP option code.
Format no option <code>
Mode
ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP
clients. Low-address and high-address are valid IP addresses; each made up of four decimal
bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format ip dhcp excluded-address <lowaddress> [highaddress]
Mode
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Format no ip dhcp excluded-address <lowaddress> [highaddress]
Mode
ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP server
sends to a pool address as part of a ping operation. By default the number of packets sent to
a pool address is 2, which is the smallest allowed number when sending packets. Setting the
number of packets to 0 disables this command.
Default
Format ip dhcp ping packets <0,2-10>
Mode
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of
packets to 0.
DHCP Pool Config
none
Global Config
Global Config
2
Global Config
Default
0