NETGEAR ProSafe GSM7224P - Page 549

Utility Commands
549
ProSafe Managed Switch
no netbios-node-type
This command removes the NetBIOS node Type.
Format no netbios-node-type
Mode
next-server
This command configures the next server in the boot process of a DHCP client.The
<address> parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
Default
Format next-server <address>
Mode
no next-server
This command removes the boot server list.
Format no next-server
Mode
option
The option command configures DHCP Server options. The <code> parameter specifies
the DHCP option code and ranges from 1-254. The <ascii string> parameter specifies
an NVT ASCII character string. ASCII character strings that contain white space must be
delimited by quotation marks. The hex <string> parameter specifies hexadecimal data. In
hexadecimal, character strings are two hexadecimal digits. You can separate each byte by a
period (for example, a3.4f.22.0c), colon (for example, a3:4f:22:0c), or white space (for
example, a3 4f 22 0c).
Default
Format option <code> {ascii string | hex <string1> [<string2>...<string8>]
| ip <address1> [<address2>...<address8>]}
Mode
DHCP Pool Config
inbound interface helper addresses
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config