NETGEAR ProSafe GSM7224P - Page 548

Utility Commands
548
ProSafe Managed Switch
no domain-name
This command removes the domain name.
Format no domain-name
Mode
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers
that are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command
line. Servers are listed in order of preference (address1 is the most preferred server,
address2 is the next most preferred server, and so on).
Default
Format netbios-name-server <address> [<address2>...<address8>]
Mode
no netbios-name-server
This command removes the NetBIOS name server list.
Format no netbios-name-server
Mode
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients. type specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default
Format netbios-node-type <type>
Mode
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config