NETGEAR ProSafe GSM7224P - Port Lacpmode; Port Lacpmode Enable All; Port-Channel Static

Switching Commands
127
ProSafe Managed Switch
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the
static mode for a new port-channel is disabled, which means the port-channel is dynamic.
However if the maximum number of allowable dynamic port-channels are already present in
the system, the static mode for a new port-channel enabled, which means the port-channel is
static.You can only use this command on port-channel interfaces.
Default
Format port-channel static
Mode
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format no port-channel static
Mode
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default
Format port lacpmode
Mode
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format no port lacpmode
Mode
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format port lacpmode enable all
Mode
disabled
Interface Config
Interface Config
enabled
Interface Config
Interface Config
Global Config