NETGEAR ProSafe GSM7224P - Permit Ip Host Mac Host; Show Ip Arp Inspection; Arp Access-List

Switching Commands
157
ProSafe Managed Switch
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Format no ip arp inspection filter acl-name vlan vlan-list [static]
Mode
arp access-list
Use this command to create an ARP ACL.
Format arp access-list acl-name
Mode
no arp access-list
Use this command to delete a configured ARP ACL.
Format no arp access-list acl-name
Mode
permit ip host mac host
Use this command to configure a rule for a valid IP address and MAC address combination
used in ARP packet validation.
Format permit ip host sender-ip mac host sender-mac
Mode
no permit ip host mac host
Use this command to delete a rule for a valid IP and MAC combination.
Format no permit ip host sender-ip mac host sender-mac
Mode
show ip arp inspection
Use this command to display the Dynamic ARP Inspection global configuration and
configuration on all the VLANs. With the vlan-list argument (i.e. comma separated VLAN
ranges), the command displays the global configuration and configuration on all the VLANs in
Global Config
Global Config
Global Config
ARP Access-list Config
ARP Access-list Config