NETGEAR ProSafe GSM7224P - Ipv6 Pim Join-Prune-Interval; Ipv6 Pim Register-Rate-Limit; Ipv6 Pim Rp-Address

IPv6 Multicast Commands
425
ProSafe Managed Switch
ipv6 pim join-prune-interval
Use this command to configure the interface join/prune interval for the PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from
0 to 18000.
Default
Format ipv6 pim join-prune-interval <0-18000>
Mode
no ipv6 pim join-prune-interval
Use this command to set the join/prune interval to the default value.
Format no ipv6 pim join-prune-interval
Mode
ipv6 pim register-rate-limit
Use this command to configure the Register Threshold rate for the Rendezvous Point router
to switch to a source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
Default
Format ipv6 pim register-rate-limit <0-2000>
Mode
no ipv6 pim register-rate-limit
Use this command to reset the register threshold rate for the Rendezvous Pointer router to
the default value.
Format no ipv6 pim register-rate-limit
Mode
ipv6 pim rp-address
Use this command to statically configure the RP address for one or more multicast groups.
The parameter <rp-address> is the IP address of the RP. The parameter
<groupaddress> is the group address supported by the RP. The parameter <groupmask>
is the group mask for the group address. The optional keyword override indicates that if
60
Interface Config
Interface Config
0
Global Config
Global Config