NETGEAR ProSafe GSM7224P - Snmp-Server Community Ro; Snmp-Server Community Rw; Snmp-Server Enable Traps Violation

Management Commands
631
ProSafe Managed Switch
snmp-server community ro
Use this command to restrict access to switch information. The access mode is read-only
(also called public).
Format snmp-server community ro <name>
Mode
snmp-server community rw
Use this command to restrict access to switch information. The access mode is read/write
(also called private).
Format snmp-server community rw <name>
Mode
snmp-server enable traps violation
Use this command to enable sending new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Note: For other port security commands, see Protected Ports Commands
on page 81.
no snmp-server enable traps violation
Use this command to disable sending new violation traps.
Format no snmp-server enable traps violation
Mode
snmp-server enable traps
Use this command to enable the Authentication Flag.
Global Config
Global Config
Default
disabled
Format snmp-server enable traps violation
Mode
Interface Config
Interface Config
Default
enabled