NETGEAR ProSafe GSM7224P - Lacp Actor Admin State Longtimeout; Lacp Actor Admin State Passive

Switching Commands
121
ProSafe Managed Switch
Note: This command is only applicable to physical interfaces.
no lacp actor admin state individual
Use this command to set the LACP actor admin state to aggregation.
Format no lacp actor admin state individual
Mode
lacp actor admin state longtimeout
Use this command to set LACP actor admin state to longtimeout.
Format lacp actor admin state longtimeout
Mode
Note: This command is only applicable to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Format no lacp actor admin state longtimeout
Mode
Note: This command is only applicable to physical interfaces.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
Format lacp actor admin state passive
Mode
Note: This command is only applicable to physical interfaces.
Interface Config
Interface Config
Interface Config
Interface Config