NETGEAR ProSafe GSM7224P - Dual Image Commands; Boot Host Dhcp

Utility Commands
504
ProSafe Managed Switch
no boot host retry-count
This command is used to reset the number to the default. The default number is 3.
Format no boot host retry-count
Mode
boot host dhcp
This command is used to enable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutroInstall and saves the command to
NVRAM.
Default
Format boot host dhcp
Mode
no boot host dhcp
This command is used to disable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutroInstall and saves the command to
NVRAM
Format no boot host dhcp
Mode
Dual Image Commands
The software supports a dual image feature that allows the switch to have two software
images in the permanent storage. You can specify which image is the active image to be
loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or
downgrade the software.
delete
This command deletes the supplied image file from the permanent storage. The image to be
deleted must be a backup image. If this image is the active image, or if this image is
activated, an error message displays. The optional <unit> parameter is valid only on
Stacks. Error will be returned, if this parameter is provided, on Standalone systems. In a
stack, the <unit> parameter identifies the node on which this command must be executed.
When this parameter is not supplied, the command is executed on all nodes in a Stack.
Format delete [<unit>] {image1 | image2}
Mode
Privileged EXEC
Enabled3
Privileged EXEC
Privileged EXEC
Privileged EXEC