NETGEAR ProSafe GSM7224P - Show Storm-Control

Switching Commands
117
ProSafe Managed Switch
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
show storm-control
This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• 802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled.
• Broadcast Storm Control Level The broadcast storm control level. The factory default is
5%.
• Multicast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Multicast Storm Control Level The multicast storm control level. The factory default is
5%.
• Unicast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Unicast Storm Control Level The unicast storm control level. The factory default is 5%.
Use the all keyword to display the per-port configuration parameters for all interfaces, or
specify the unit/slot/port to display information about a specific interface.
Format show storm-control [all | <unit/slot/port>]
Mode
Format no storm-control flowcontrol
Mode
Global Config
Privileged EXEC
Term Definition
Bcast Mode
Shows whether the broadcast storm control mode is enabled or disabled. The factory
default is disabled.
Bcast Level
The broadcast storm control level.
Mcast Mode
Shows whether the multicast storm control mode is enabled or disabled.
Mcast Level
The multicast storm control level.