NETGEAR ProSafe GSM7224P - Show Monitor Session; No Monitor

Switching Commands
135
ProSafe Managed Switch
destination interface <unit/slot/port> to remove the specified interface from
the port monitoring session. Use the mode parameter to disable the administrative mode of
the session
Note: Since the current version of 7000 series software only supports one
session, if you do not supply optional parameters, the behavior of
this command is similar to the behavior of the no monitor
command.
.
no monitor
This command removes all the source ports and a destination port for the and restores the
default value for mirroring session mode for all the configured sessions.
Note: This is a stand-alone “no” command. This command does not have
a “normal” form.
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify
the session. In the current version of the software, the
<session-id> parameter is always one (1)
Format no monitor session <session-id> [{source interface <unit/slot/port>
| destination interface <unit/slot/port> | mode}]
Mode
Global Config
Default
enabled
Format no monitor
Mode
Global Config
Format show monitor session
<session-id>
Mode
Privileged EXEC