NETGEAR ProSafe GSM7224P - Ip Vrrp Authentication; Ip Vrrp Preempt

Routing Commands
256
ProSafe Managed Switch
no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the
interface. To delete the primary IP address, you must delete the virtual router on the interface.
Format no ip vrrp <vrid> <ipaddress> secondary
Mode
ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a
specified interface. The parameter {none | simple} specifies the authorization type for
virtual router configured on the specified interface. The parameter [key] is optional, it is only
required when authorization type is simple text password. The parameter <vrid> is the
virtual router ID which has an integer value ranges from 1 to 255.
Default
Format ip vrrp <vrid> authentication {none | simple <key>}
Mode
no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on
a specified interface.
Format no ip vrrp <vrid> authentication
Mode
ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a
specified interface. The parameter <vrid> is the virtual router ID, which is an integer from 1
to 255.
Default
Format ip vrrp <vrid> preempt
Mode
Format ip vrrp <vrid> ip <ipaddr> [secondary]
Mode
Interface Config
Interface Config
no authorization
Interface Config
Interface Config
enabled
Interface Config