Routing Commands
235
ProSafe Managed Switch
no arp timeout
This command configures the default ARP entry ageout time.
Format no arp timeout
Mode
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If
the gateway keyword is specified, the dynamic entries of type gateway are purged as well.
Format clear arp-cache [gateway]
Mode
clear arp-switch
Use this command to clear the contents of the switch’s Address Resolution Protocol (ARP)
table that contains entries learned through the Management port. To observe whether this
command is successful, ping from the remote system to the DUT. Issue the show arp
switch command to see the ARP entries. Then issue the clear arp-switch command
and check the show arp switch entries. There will be no more arp entries.
Format clear arp-switch
Mode
show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results
are not the total ARP entries. To view the total ARP entries, the operator should view the
show arp results in conjunction with the show arp switch results.
Format show arp
Mode
Global Config
Privileged EXEC
Privileged EXEC
Privileged EXEC
Term Definition
Age Time
(seconds)
The time it takes for an ARP entry to age out. This is configurable. Age time is
measured in seconds.
Response Time
(seconds)
The time it takes for an ARP request timeout. This value is configurable. Response
time is measured in seconds.
Retries
The maximum number of times an ARP request is retried. This value is configurable.
Cache Size
The maximum number of entries in the ARP table. This value is configurable.
Dynamic Renew
Mode
Displays whether the ARP component automatically attempts to renew dynamic ARP
entries when they age out.
To Next Page
Loading...
