Routing Commands
255
ProSafe Managed Switch
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the
interface. The parameter <vrid> is the virtual router ID, which has an integer value range
from 1 to 255.
Format ip vrrp <vrid>
Mode
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the
interface. The virtual Router ID, <vrid>, is an integer value that ranges from 1 to 255.
Format no ip vrrp <vrid>
Mode
ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the
status field starts a virtual router. The parameter <vrid> is the virtual router ID which has an
integer value ranging from 1 to 255.
Default
Format ip vrrp <vrid> mode
Mode
no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the
status field stops a virtual router.
Format no ip vrrp <vrid> mode
Mode
ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for
<ipaddr> is the IP address which is to be configured on that interface for VRRP. The
parameter <vrid> is the virtual router ID which has an integer value range from 1 to 255.
You can use the optional [secondary] parameter to designate the IP address as a
secondary IP address.
Interface Config
Interface Config
disabled
Interface Config
Interface Config
Default
none
To Next Page
Loading...
