NETGEAR ProSafe GSM7224P - Show Supported Switchtype

Stacking Commands
28
ProSafe Managed Switch
show supported switchtype
This commands displays information about all supported switch types or a specific switch
type.
Format show supported switchtype [<switchindex>]
Mode
If you do not supply a value for <switchindex>, the following output appears:
Switch Index (SID)
Model Identifier
Management
Preference
Code Version
If you supply a value for <switchindex>, the following output appears:
Switch Type
Model Identifier
Switch
Description
Model Identifier
The model identifier for this switch. Model Identifier is a 32-character field assigned by
the device manufacturer to identify the device.
Switch Status
The switch status. Possible values are OK, Unsupported, Code Mismatch, Config
Mismatch, or Not Present.
Switch
Description
The switch description.
Expected Code
Version
The expected code version.
Detected Code
Version
The version of code running on this switch. If the switch is not present and the data is
from pre-configuration, then the code version is “None”.
Detected Code in
Flash
The version of code that is currently stored in FLASH memory on the switch. This code
executes after the switch is reset. If the switch is not present and the data is from
pre-configuration, then the code version is “None”.
Up Time
The system up time.
User EXEC
Privileged EXEC
Term Definition
The index into the database of supported switch types. This index is used when
preconfiguring a member to be added to the stack.
The model identifier for the supported switch type.
The management preference value of the switch type.
The code load target identifier of the switch type.
Term Definition
The 32-bit numeric switch type for the supported switch.
The model identifier for the supported switch type.
The description for the supported switch type.
Term Definition