NETGEAR ProSafe GSM7224P - Lacp Partner Port ID; Lacp Partner Port Priority

Switching Commands
125
ProSafe Managed Switch
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is 0
to 65535.
Default
Format lacp partner portid <port-id>
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format no lacp partner portid
Mode
lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for
<priority> is 0 to 255.
Default
Format lacp partner port priority <priority>
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format no lacp partner port priority
Mode
0x80
Interface Config
Interface Config
0x0
Interface Config
Interface Config