NETGEAR ProSafe GSM7224P - Show Diffserv Service; Show Diffserv Service Brief

Quality of Service (QoS) Commands
468
ProSafe Managed Switch
show diffserv service
This command displays policy service information for the specified interface and direction.
The <unit/slot/port> parameter specifies a valid unit/slot/port number for the system.
Format show diffserv service <unit/slot/port> [in | out]
Mode
DiffServ Admin
Mode
Interface
Direction
Operational
Status
Policy Name
Policy Details
show diffserv service brief
This command displays all interfaces in the system to which a DiffServ policy has been
attached. The inbound direction parameter is optional.
Format show diffserv service brief [in | out]
Mode
DiffServ Admin
Mode
The following information is repeated for interface and direction (only those interfaces
configured with an attached policy are shown):
Interface
Direction
OperStatus
Policy Name
Privileged EXEC
Term Definition
The current setting of the DiffServ administrative mode. An attached policy is only in
effect on an interface while DiffServ is in an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface in the indicated direction.
Attached policy details, whose content is identical to that described for the show
policy-map <policymapname> command (content not repeated here for brevity).
Privileged EXEC
Term Definition
The current setting of the DiffServ administrative mode. An attached policy is only active
on an interface while DiffServ is in an enabled mode.
Term Definition
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface in the indicated direction.