NETGEAR ProSafe GSM7224P - Show Ip Vrrp Interface Brief

Routing Commands
262
ProSafe Managed Switch
The following shows example CLI display output for the command.
(Switch)#show ip vrrp interface 1/0/1 1
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State DecrementPriority
--------------- ------ ------------------
<1/0/1> down 10
TrackRoute (pfx/len) State DecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format show ip vrrp interface brief
Modes
• Privileged EXEC
• User EXEC
Configured
Priority
The priority configured through the ip vrrp <vrid> priority <1-254> command.
Advertisement
interval
The advertisement interval in seconds for the specific virtual router.
Pre-Empt Mode
The preemption mode configured on the specified virtual router.
Administrative
Mode
The status (Enable or Disable) of the specific router.
State
The state (Master/backup) of the virtual router.
Term Definition
Interface
Valid slot and port number separated by forward slashes.
VRID
The router ID of the virtual router.
IP Address
The virtual router IP address.
Term Definition