Management Commands
626
ProSafe Managed Switch
Note: If the default list is not set, only the enable password is checked.
This has the same effect as the following command:
aaa authentication enable default enable
On the console, the enable password is used if it exists. If no
password is set, the process will succeed anyway. This has the
same effect as the following command:
aaa authentication enable default enable none
no aaa authentication enable
Use this command to remove the authentication method.
Format no aaa authentication enable {default | list-name} method1
[method2...]
Mode
aaa authentication dot1x
Use this command to set authentication for dot1x users. The method argument identifies the
list of methods that the authentication algorithm tries, in the given sequence. The additional
methods of authentication are used only if the previous method returns an error, not if there is
an authentication failure. To ensure that the authentication succeeds even if all methods
return an error, specify
none as the final method in the command line. For example if none is
specified as an authentication method after radius, no authentication is used if the radius
server is down.
Format aaa authentication dot1x default method1 [method2...]
Mode
method1 [method2…] At least one from the following table:
local
none
radius
ias
Global Config
Global Config
Keyword Description
Uses the local username database for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication.
Uses the internal authentication server users database for authentication.
To Next Page
Loading...
