NETGEAR ProSafe GSM7224P - Distance Rip; Default-Information Originate (Rip); Default-Metric (Rip)

Routing Commands
310
ProSafe Managed Switch
default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format default-information originate
Mode
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format no default-information originate
Mode
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format default-metric <0-15>
Mode
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format no default-metric
Mode
distance rip
This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route. A route with a preference of 255
cannot be used to forward traffic.
Default
Format distance rip <1-255>
Mode
no distance rip
This command sets the default route preference value of RIP in the router.
Format no distance rip
Mode
Router RIP Config
Router RIP Config
Router RIP Config
Router RIP Config
15
Router RIP Config
Router RIP Config