NETGEAR ProSafe GSM7224P - Timers Spf; Passive-Interface Default (Ospf)

Routing Commands
287
ProSafe Managed Switch
passive-interface default (OSPF)
Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF will not form adjacencies over a passive interface.
Default
Format passive-interface default
Mode
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
Format no passive-interface default
Mode
passive-interface (OSPF)
Use this command to set the interface or tunnel as passive. It overrides the global passive
mode that is currently effective on the interface or tunnel.
Default
Format passive-interface {<unit/slot/port>}
Mode
no passive-interface
Use this command to set the interface or tunnel as non-passive. It overrides the global
passive mode that is currently effective on the interface or tunnel.
Format no passive-interface {<unit/slot/port>}
Mode
timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both
parameters is 0-65535 seconds.
Default
• delay-time—5
• hold-time—10
Format timers spf <delay-time> <hold-time>
Mode
disabled
Router OSPF Config
Router OSPF Config
disabled
Router OSPF Config
Router OSPF Config
Router OSPF Config