NETGEAR ProSafe GSM7224P - Ipv6 Pim Ssm; Show Ipv6 Pim Bsr-Router

IPv6 Multicast Commands
427
ProSafe Managed Switch
no ipv6 pim spt-threshold
This command is used to set the Data Threshold rate for the RP router to the default value.
Format no ipv6 pim spt-threshold
Mode
ipv6 pim ssm
Use this command to define the Source Specific Multicast (SSM) range of IP multicast
addresses.
Default
Format ipv6 pim ssm {default | <group-address/prefixlength> <group-mask>}
Mode
default
no ipv6 pim ssm
Use this command to disable the Source Specific Multicast (SSM) range.
Format no ipv6 pim ssm
Mode
show ipv6 pim bsr-router
Use command to display the bootstrap router (BSR) information. The output includes elected
BSR information and information about the locally configured candidate rendezvous point
(RP) advertisement.
Format show ipv6 pim bsr-router [candidate | elected]
Mode
• Privileged EXEC
• User EXEC
Global Config
disabled
Global Config
Parameter Description
Defines the SSM range access list to 232/8.
Global Config
Term Definition
BSR Address
IP address of the BSR.
Uptime
Length of time that this router has been up (in hours, minutes, and seconds).
BSR Priority
Priority as configured in the ip pim bsr-candidate command.
Hash Mask
Length
Length of a mask (maximum 32 bits) that is to be ANDed with the group address
before the hash function is called. This value is configured in the ip pim
bsr-candidate command.