NETGEAR ProSafe GSM7224P - Show Ip Mcast; Show Ip Mcast Boundary; Show Ip Mcast Interface

IP Multicast Commands
321
ProSafe Managed Switch
show ip mcast
This command displays the system-wide multicast information.
Format show ip mcast
Modes
• Privileged EXEC
• User EXEC
Admin Mode
Protocol State
Table Max Size
Protocol
Multicast
Forwarding
Cache Entry
Count
show ip mcast boundary
This command displays all the configured administrative scoped multicast boundaries.
Format show ip mcast boundary {<unit/slot/port> | all}
Modes
• Privileged EXEC
• User EXEC
Interface
Group Ip
Mask
show ip mcast interface
This command displays the multicast information for the specified interface.
Format show ip mcast interface <unit/slot/port>
Modes
• Privileged EXEC
• User EXEC
Term Definition
The administrative status of multicast. Possible values are enabled or disabled.
The current state of the multicast protocol. Possible values are Operational or
Non-Operational.
The maximum number of entries allowed in the multicast table.
The multicast protocol running on the router. Possible values are PIM-DM, PIM-SM, or
DVMRP.
The number of entries in the multicast forwarding cache.
Term Definition
Valid slot and port number separated by forward slashes.
The group IP address.
The group IP mask.