NETGEAR ProSafe GSM7224P - Area Default-Cost (Ospf); Area Nssa (Ospf)

Routing Commands
270
ProSafe Managed Switch
no ip ospf area
Use this command to disable OSPF on an interface.
Format no ip ospf area [secondaries none]
Mode
1583compatibility
This command enables OSPF 1583 compatibility.
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
no 1583compatibility
This command disables OSPF 1583 compatibility.
Format no 1583compatibility
Mode
area default-cost (OSPF)
This command configures the default cost for the stub area. You must specify the area ID and
an integer value between 1-16777215.
Format area <areaid> default-cost <1-16777215>
Mode
area nssa (OSPF)
This command configures the specified areaid to function as an NSSA.
Format area <areaid> nssa
Mode
Interface Config
Default
enabled
Format 1583compatibility
Mode
Router OSPF Config
Router OSPF Config
Router OSPF Config
Router OSPF Config