NETGEAR ProSafe GSM7224P - Macfilter Addsrc; Macfilter Addsrc All

Switching Commands
138
ProSafe Managed Switch
Note: Configuring a destination port list is only valid for multicast MAC
addresses.
no macfilter adddest all
This command removes all ports from the destination filter set for the MAC filter with the
given <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as
a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter
must identify a valid VLAN.
Format no macfilter adddest all <macaddr> <vlanid>
Mode
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid>
parameter must identify a valid VLAN.
Format macfilter addsrc <macaddr> <vlanid>
Mode
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be
specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
<vlanid> parameter must identify a valid VLAN.
Format no macfilter addsrc <macaddr> <vlanid>
Mode
macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the MAC
address of <macaddr> and <vlanid>. You must specify the <macaddr> parameter as a
Format macfilter adddest all <macaddr> <vlanid>
Mode
Global Config
Global Config
Interface Config
Interface Config