NETGEAR ProSafe GSM7224P - Network (Dhcp Pool Config)

Utility Commands
547
ProSafe Managed Switch
network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
Default
Format network <networknumber> [{<mask> | <prefixlength>}]
Mode
no network
This command removes the subnet number and mask.
Format no network
Mode
bootfile
The command specifies the name of the default boot image for a DHCP client. The
<filename> specifies the boot image file.
Format bootfile <filename>
Mode
no bootfile
This command deletes the boot image name.
Format no bootfile
Mode
domain-name
This command specifies the domain name for a DHCP client. The <domain> specifies the
domain name string of the client.
Default
Format domain-name <domain>
Mode
none
DHCP Pool Config
DHCP Pool Config
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config