Utility Commands
546
ProSafe Managed Switch
no hardware-address
This command removes the hardware address of the DHCP client.
Format no hardware-address
Mode
host
This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default
Format host <address> [{<mask> | <prefix-length>}]
Mode
no host
This command removes the IP address of the DHCP client.
Format no host
Mode
lease
This command configures the duration of the lease for an IP address that is assigned from a
DHCP server to a DHCP client. The overall lease time should be between 1-86400 minutes.
If you specify infinite, the lease is set for 60 days. You can also specify a lease duration.
Days is an integer from 0 to 59. Hours is an integer from 0 to 23. Minutes is an integer from
0 to 59.
Default
Format lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode
no lease
This command restores the default value of the lease time for DHCP Server.
Format no lease
Mode
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config
1 (day)
DHCP Pool Config
DHCP Pool Config
To Next Page
Loading...
