NETGEAR ProSafe GSM7224P - Page 545

Utility Commands
545
ProSafe Managed Switch
default-router
This command specifies the default router list for a DHCP client. {address1, address2…
address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Default
Format default-router <address1> [<address2>....<address8>]
Mode
no default-router
This command removes the default router list.
Format no default-router
Mode
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are
valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default
Format dns-server <address1> [<address2>....<address8>]
Mode
no dns-server
This command removes the DNS Server list.
Format no dns-server
Mode
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the
MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10 MB
Ethernet and 6 for IEEE 802.
Default
Format hardware-address <hardwareaddress> <type>
Mode
none
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config
ethernet
DHCP Pool Config