NETGEAR ProSafe GSM7224P - Chapter 8 IPv6 Multicast Commands

417
8
8. IPv6 Multicast Commands
This chapter describes the IPv6 multicast commands available in the managed switch CLI.
Note: Commands described in this chapter that require a license are:
IPv6 Multicast Forwarder Commands
IPv6 PIM Commands
IPv6 MLD Commands
IPv6 MLD-Proxy Commands
This chapter contains the following sections:
• IPv6 Multicast Forwarder Commands on page 418
• IPv6 PIM Commands on page 420
• IPv6 MLD Commands on page 428
• IPv6 MLD-Proxy Commands on page 434
The commands in this chapter are in three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
Note: There is no specific IP multicast enable for IPv6. Enabling of
multicast at global config is common for both IPv4 and IPv6.