Utility Commands
539
ProSafe Managed Switch
sntp server
This command configures an SNTP server (a maximum of three). The optional priority can be
a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format sntp server <ipaddress|ipv6address| hostname> [<priority> [<version>
[<portid>]]]
Mode
no sntp server
This command deletes an server from the configured SNTP servers.
Format no sntp server remove <ipaddress|ipv6address| hostname>
Mode
clock timezone
When using SNTP/NTP time servers to update the switch’s clock, the time data received
from the server is based on Coordinated Universal Time (UTC) which is the same as
Greenwich Mean Time (GMT). This may not be the time zone in which the switch is located.
Use the clock timezone command to configure a time zone specifying the number of hours
and optionally the number of minutes difference from UTC. To set the switch clock to UTC,
use the no form of the command.
Format
Mode
Default no clock timezone
Zone name: A name to associate with the time zone
Hours-offset: Number of hours difference with UTC
Minutes-offset: Number of minutes difference with UTC
no clock timezone
This command sets the switch to UTC time.
Format no clock timezone
Mode
clock summer-time recurring
Use the clock summer-time recurring command to set the summertime offset to UTC
recursively every year. If the optional parameters are not specified, they are read as either '0'
or '\0', as appropriate.
Global Config
Global Config
clock timezone zone-name +/-hours-offset [+/-minutes-offset]
Global Config
Global Config
To Next Page
Loading...
