NETGEAR ProSafe GSM7224P - Area Stub No-Summary (Ospfv); Area Virtual-Link (Ospfv); Area Virtual-Link Dead-Interval (Ospfv)

IPv6 Commands
384
ProSafe Managed Switch
area stub no-summary (OSPFv3)
This command disables the import of Summary LSAs for the stub area identified by
<areaid>.
Default
Format area <areaid> stub no-summary
Mode
no area stub no-summary(OSPFv3)
This command sets the Summary LSA import mode to the default for the stub area identified
by <areaid>.
Format no area <areaid> stub summarylsa
Mode
area virtual-link (OSPFv3)
This command creates the OSPF virtual interface for the specified <areaid> and
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
Format area <areaid> virtual-link <neighbor>
Mode
no area virtual-link(OSPFv3)
This command deletes the OSPF virtual interface from the given interface, identified by
<areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
Format no area <areaid> virtual-link <neighbor>
Mode
area virtual-link dead-interval (OSPFv3)
This command configures the dead interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for <seconds> is 1 to 65535.
Default
Format area <areaid> virtual-link <neighbor> dead-interval
<seconds>
Mode
enabled
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config
40
Router OSPFv3 Config