NETGEAR ProSafe GSM7224P - Show Lacp Partner; Show Port-Channel Brief

Switching Commands
132
ProSafe Managed Switch
show lacp partner
Use this command to display LACP partner attributes.
Format show lacp partner {<unit/slot/port>|all}
Mode
The following output parameters are displayed.
System Priority
System ID
Admin Key
Port Priority
Port-ID
Admin State
show port-channel brief
This command displays the static capability of all port-channel (LAG) interfaces on the device
as well as a summary of individual port-channel interfaces.
Format show port-channel brief
Mode
• Privileged EXEC
• User EXEC
For each port-channel the following information is displayed:
Logical
Interface
Port-channel
Name
Link-State
Trap Flag
Type
Mbr Ports
Active Ports
Privileged EXEC
Parameter Description
The administrative value of priority associated with the Partner’s System ID.
The value representing the administrative value of the Aggregation Port’s protocol
Partner’s System ID.
The administrative value of the Key for the protocol Partner.
The administrative value of the port priority for the protocol Partner.
The administrative value of the port number for the protocol Partner.
The administrative values of the actor state for the protocol Partner.
Term Definition
The unit/slot/port of the logical interface.
The name of port-channel (LAG) interface.
Shows whether the link is up or down.
Shows whether trap flags are enabled or disabled.
Shows whether the port-channel is statically or dynamically maintained.
The members of this port-channel.
The ports that are actively participating in the port-channel.