NETGEAR ProSafe GSM7224P - Ip Rip Authentication; Ip Rip Receive Version; Distribute-List out (Rip)

Routing Commands
311
ProSafe Managed Switch
distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source
protocol.
Default
Format distribute-list <1-199> out {ospf | static | connected}
Mode
no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format no distribute-list <1-199> out {ospf | static | connected}
Mode
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <type> is either none, simple, or encrypt. The value for
authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of
<type> is encrypt, a keyid in the range of 0 and 255 must be specified. Unauthenticated
interfaces do not need an authentication key or authentication key ID.
Default
Format ip rip authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format no ip rip authentication
Mode
ip rip receive version
This command configures the interface to allow RIP control packets of the specified
version(s) to be received.
0
Router RIP Config
Router RIP Config
none
Interface Config
Interface Config