NETGEAR ProSafe GSM7224P - Arp Retries; Arp Timeout

Routing Commands
234
ProSafe Managed Switch
The value for <seconds> is a valid positive integer, which represents the IP ARP entry
response timeout time in seconds. The range for <seconds> is between 1-10 seconds.
Default
Format arp resptime <1-10>
Mode
no arp resptime
This command configures the default ARP request response timeout.
Format no arp resptime
Mode
arp retries
This command configures the ARP count of maximum request for retries.
The value for <retries> is an integer, which represents the maximum number of request
for retries. The range for <retries> is an integer between 0-10 retries.
Default
Format arp retries <0-10>
Mode
no arp retries
This command configures the default ARP count of maximum request for retries.
Format no arp retries
Mode
arp timeout
This command configures the ARP entry ageout time.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry
ageout time in seconds. The range for <seconds> is between 15-21600 seconds.
Default
Format arp timeout <15-21600>
Mode
1
Global Config
Global Config
4
Global Config
Global Config
1200
Global Config