21
2
2. Stacking Commands
This chapter contains the following sections:
• Dedicated Port Stacking
• Front Panel Stacking Commands
• Non-Stop Forwarding Commands
• Stack Firmware Synchronization Commands
The commands in this chapter are in two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
The Primary Management Unit is the unit that controls the stack.
Dedicated Port Stacking
This section describes the commands you use to configure dedicated port stacking.
stack
This command sets the mode to Stack Global Config.
Format stack
Mode
member
This command configures a switch. The <unit> is the switch identifier of the switch to be
added/removed from the stack. The <switchindex> is the index into the database of the
supported switch types, indicating the type of the switch being preconfigured. The switch
index is a 32-bit integer. This command is executed on the Primary Management Unit.
Format member <unit> <switchindex>
Mode
Global Config
Stack Global Config
To Next Page
Loading...
