NETGEAR ProSafe GSM7224P - PIM Commands

IP Multicast Commands
329
ProSafe Managed Switch
PIM Commands
This section describes the commands you use to configure Protocol Independent Multicast
(PIM). PIM is a multicast routing protocol that provides scalable inter-domain multicast
routing across the Internet, independent of the mechanisms provided by any particular
unicast routing protocol.
ip pim dense (Global Config)
This command enables the administrative mode of PIM-DM in the router.
Default
Format ip pim dense
Mode
no ip pim dense (Global Config)
This command disables the administrative mode of PIM-DM in the router.
Format no ip pim dense
Mode
ip pim (Interface Config)
This command sets administrative mode of PIM on an interface to enabled.
Default
Format ip pim
Mode
no ip pim (Interface Config)
This command sets administrative mode of PIM on an interface to disabled.
Format no ip pim
Mode
Expiry Time
(secs)
The expiry time in seconds, which is the time left for this route to age out.
Up Time (secs)
The time when a specified route was learnt, in seconds.
Disabled
Global Config
Global Config
disabled
Interface Config
Interface Config
Term Definition